Configuring the Wireless Network
Basic Settings
Cisco RV220W Administration Guide 59
3
• Allow—Accept connections only from the endpoints identified in the
Connection Control List. Access is denied from all other clients.
STEP 4 In the Connection Control List, enter the MAC address of each client that is
subject to MAC filtering.
Tip: To view a list of current clients, you can click the Wireless Clients List button.
Any unsaved changes on this page will be abandoned. The Connected Clients list
displays the MAC address, connection settings, and connection time for all
connected clients. To copy an address, use your mouse to select it, then right-click
and choose Copy. You can click the browser’s Back button to return to the
Connection Control List, where you can paste the copied address into a MAC
address field.
STEP 5 Click Save to save your settings, or click Cancel to reload the page with the
current settings. Click Back to return to the Wireless > Basic Settings page.
If you need to configure the settings for another network, select it from the Select
SSID list, and then repeat this procedure.
Connected Clients
Use the Connected Clients page to display information about the clients that are
connected to a selected wireless network
To open this page: From the MAC Filtering page, click the Wireless Clients List
button.
The Connected Clients list displays the MAC address, connection settings, and
connection time for all connected clients.
Tip: To copy an address, use your mouse to select it, then right-click and choose
Copy. You can click the browser’s Back button to return to the Connection Control
List, where you can paste the copied address into a MAC address field.
To Next Page
Loading...
Need help?
General
