Configuring Networking
IPv6
Cisco RV220W Administration Guide 43
2
• To remove an entry, check the box and then click Delete.
STEP 4 Click Save to save your settings, or click Cancel to reload the page with the
current settings. After saving or cancelling, you can add, edit, or delete other
entries.
Configuring IPv6 Static Routing
You can configure static routes to direct packets to the destination network. A
static route is a pre-determined pathway that a packet must travel to reach a
specific host or network.
Some ISPs require static routes to build your routing table instead of using
dynamic routing protocols. Static routes do not require CPU resources to
exchange routing information with a peer router or RV220W.
You can also use static routes to reach peer routers and RV220Ws that do not
support dynamic routing protocols. Static routes can be used together with
dynamic routes. Be careful not to introduce routing loops in your network.
• Managing IPv6 Static Routes
• Configuring an IPv6 Static Route
Managing IPv6 Static Routes
Use the Networking > IPv6 > Routing page to view, add, edit, or delete static
routes.
To open this page: In the navigation tree, choose Networking > IPv6 > Routing.
Perform these tasks:
• To add a new route, click Add. Then enter the settings on the Add / Edit
Static Route Configuration page. For more information, see Configuring an
IPv6 Static Route, page 44.
• To edit a route, check the box, and then click Edit. Then enter the settings on
the Add / Edit Static Route Configuration page. For more information, see
Configuring an IPv6 Static Route, page 44.
• To delete a route, check the box, and then click Delete. When the
confirmation message appears, click OK to continue with the deletion, or
otherwise, click Cancel.
To Next Page
Loading...
Need help?
General
