Cisco Small Business RV220W Administration Guide

Configuring Networking
Routing
Cisco RV220W Administration Guide 31
2
Routing
Use the Networking > Routing menu to configure the following features:
• Routing Mode, page 31
• Routing Table, page 32
• Static Routes, page 33
• Dynamic Routing, page 35
Routing Mode
The Cisco RV220W provides two different routing modes: Gateway (NAT) and
Router.
To open this page: In the navigation tree, choose Networking > Routing >
Routing Mode.
STEP 1 Choose one of the following options:
• Gateway (NAT)—If your ISP has assigned you a single IP address, select
this option to use Network Address Translation (NAT) to allow devices in
your private network to share your public IP address.
• Router—This routing mode, “classical routing,” is used if your ISP has
assigned you multiple IP addresses so that you have an IP address for each
endpoint on your network. You must configure either static or dynamic
routes if you use this type of routing. See Static Routes, page 33, or
Dynamic Routing, page 35.
STEP 2 Click Save to save your settings, or click Cancel to reload the page with the
current settings.

Cisco Small Business RV220W Specifications

General

Firewall Type	Stateful packet inspection (SPI)
VPN Support	Yes
DHCP Server	Yes
QoS	Yes
Wireless Speed	300 Mbps
Management	Web-based
LAN Ports	4
Encryption	AES
Security Features	NAT, URL filtering
Power Supply	12V DC
Wireless Standard	802.11n
WAN Ports	1