Cisco Small Business RV220W Administration Guide

Configuring Virtual Private Networks (VPNs) and Security
SSL VPN Tunnel Client Configuration
Cisco RV220W Administration Guide 138
6
Configured Client Routes for Split Tunnel Mode
Client routes are required if you enabled Split Tunnel mode for SSL VPN clients.
The Configured Client Routes entries are added by the SSL VPN Client such that
only traffic to these destination addresses is redirected through the SSL VPN
tunnels, and all other traffic is redirected using the hosts (SSL VPN Clients) native
network interface. For example if the SSL VPN Client attempts to access this
device’s LAN network then in Split Tunnel mode, the user should add the LAN
subnet as the Destination Network using this page.
• Managing Client Routes, page 138
• Configuring a Client Route, page 139
Managing Client Routes
Use the VPN > SSL VPN Client > Configured Client Routes page to configure
client routes. This feature is available only if you enabled Split Tunnel Support on
the SSL VPN Client page.
To open this page: In the navigation tree, choose VPN > SSL VPN Client >
Configured Client Routes.
Perform these tasks:
• To add a route, click Add. Then enter the settings on the SSL VPN Client
Route Configuration page. See Configuring a Client Route, page 139.
• To edit a route, check the box and then click Edit. Then enter the settings on
the SSL VPN Client Route Configuration page. See Configuring a Client
Route, page 139.
• To delete a route, check the box and then click Delete. To select all routes,
check the box in the heading row, and then click Delete. When the
confirmation message appears, click OK to continue with the deletion, or
otherwise click Cancel.

Cisco Small Business RV220W Specifications

General

Firewall Type	Stateful packet inspection (SPI)
VPN Support	Yes
DHCP Server	Yes
QoS	Yes
Wireless Speed	300 Mbps
Management	Web-based
LAN Ports	4
Encryption	AES
Security Features	NAT, URL filtering
Power Supply	12V DC
Wireless Standard	802.11n
WAN Ports	1