Cisco Small Business RV220W - Adding or Editing a RADIUS Server Configuration

Configuring Security
Using the Cisco RV220W With a RADIUS Server
Cisco RV220W Administration Guide 147
7
Adding or Editing a RADIUS Server Configuration
Use the Add / Edit RADIUS Server Configuration page to configure a RADIUS
server to use for authentication.
To open this page: From the Security > RADIUS Server page, click Add or select
a server and then click Edit.
STEP 1 Enter this information:
• Authentication Server IP Address—Enter the IP address of the
authenticating RADIUS Server.
• Authentication Port—Enter the port number on which the RADIUS server
sends traffic.
• Secret—Enter the shared key that allows the Cisco RV220W to authenticate
with the RADIUS server. This key must match the key configured on the
RADIUS server. The single quote, double quote, and space characters are
not allowed in this field.
• Timeout—Enter the timeout interval after which the Cisco RV220W re-
authenticates with the RADIUS server.
• Retries—Enter the number of retries for the Cisco RV220W to re-
authenticate with the RADIUS server.
STEP 2 Click Save to save your settings, or click Cancel to reload the page with the
current settings. Click Back to return to the Security > RADIUS Server page.