Cisco Small Business RV220W - Configuring SNMP Traps; SNMP System Information

Administering Your Cisco RV220W
Network Management (SNMP)
Cisco RV220W Administration Guide 171
9
Configuring SNMP Traps
Use the Add / Edit Trap Configuration page to identify SNMP agents to which the
router will send trap messages (notifications).
To open this page: From the Administration > Network Management > SNMP
page, in the Traps Table, click Add or select a trap and then click Edit.
STEP 1 Enter these settings:
• IP Address—Enter the IP address of the SNMP manager or trap agent.
• Port—Enter the SNMP trap port of the IP address to which the trap
messages will be sent.
• SNMP Version—Choose the SNMP Version: v1, v2c, or v3.
• Community—Enter the community string to which the agent belongs. Most
agents are configured to listen for traps in the Public community.
STEP 2 Click Save to save your settings, or click Cancel to reload the page with the
current settings. Click Back to return to the Administration > Network
Management > SNMP page.
SNMP System Information
Use the Administration > Network Management > SNMP System Information
page to specify reference information for your SNMP Management Information
Base (MIB).
To open this page: In the navigation tree, choose Administration > Network
Management > SNMP System Information.
STEP 1 Enter the following MIB (Management Information Base) settings:
• SysContact—Enter the name of the contact person for this router. Examples:
admin, John Doe.
• SysLocation—Enter the physical location of this router. Example: Rack #2,
4th Floor.