Administering Your Cisco RV220W
Time Settings
Cisco RV220W Administration Guide 184
9
• Internal Port—Indicates which, if any, internal ports are opened by the
UPnP device.
• External Port—Indicates which, if any, external ports are opened by the
UPnP device.
• IP Address—The IP address of the UPnP device that is accessing this router.
STEP 5 Click Save to save your settings, or click Cancel to reload the page with the
current settings.
Time Settings
Use the Administration > Time Settings page to configure the date and time
settings for your Cisco RV220W. After choosing your time zone and Daylight
Savings Time settings, if applicable, you can enter the time manually or specify a
Network Time Protocol (NTP) server to provide the time settings for your network.
To open this page: In the navigation tree, choose Administration > Time Settings.
The date, time, and time zone appear at the top of the page.
STEP 1 In the Time Settings section, enter the following settings:
• Date/Time—Select your time zone, relative to Greenwich Mean Time
(GMT).
• Adjust for Daylight Savings Time—Check Enable to adjust the time
automatically for daylight Saving Time, if applicable in your region. Then
enter these settings:
- From—Enter the date when Daylight Savings Time begins in your region.
- To—Enter the date when Daylight Savings Time ends in your region.
- Daylight Savings Offset—Choose the amount of the adjustment, in
minutes. The default setting is to add 60 minutes to the time, in keeping
with the common practice to “spring forward” one hour during Daylight
Savings Time.
• Clock Source—Choose whether to Use NTP server to provide your time
settings or to Set Date and Time Manually. The default option is to use an
NTP server.
To Next Page
Loading...
Need help?
General
