Configuring Networking
Port Management
Cisco RV220W Administration Guide 37
2
Port Management
The Cisco RV220W has four LAN ports and a dedicated WAN port. You can enable
or disable ports, configure the duplex mode, and set the port speed.
To open this page: In the navigation tree, choose Networking > Port
Management.
STEP 1 Update the port settings as needed:
• Enable—Check this box to enable a port, or uncheck this box to disable the
port. By default, all ports are enabled. The LAN 1 port is always enabled and
cannot be disabled.
• Auto Negotiation—Check this box to allow the RV220W and network
determine the optimal port settings (recommended). Uncheck this box to
manually set the duplex mode and speed. Auto Negotiation is enabled by
default. This setting is available only when the Enable box is checked.
• Duplex—If you disabled Auto Negotiation, choose either half- or full-duplex
based on the port support. The default is full-duplex for all ports. This setting
is available only when the Auto Negotiation box is unchecked.
• Speed—If you disabled Auto Negotiation, choose one of the following port
speeds: 10 Mbps, 100 Mbps, or 1000 Mbps. The default setting is
1000 Mbps for all ports. This setting is available only when the Auto
Negotiation box is unchecked. You can change the port speed if a network
is designed to run at a particular speed, such as 10 Mbps mode. For
example, you may want to change the port to 10 Mbps if the endpoint also
uses 10 Mbps mode, either by auto-negotiation or manual setting.
STEP 2 Click Save to save your settings, or click Cancel to reload the page with the
current settings.
To Next Page
Loading...
Need help?
General
