Firewall
Advanced Firewall Settings
Cisco RV220W Administration Guide 87
4
STEP 2 After making changes, click Save to save your settings, or click Cancel to reload
the page with the current settings.
Custom Services
Each firewall rule applies to a specific type of service. Common types of services
are pre-configured and can be selected from the Service list when you configure
an access rule. (See Adding and Editing Access Rules, page 67.) As needed, you
can add services to the list.
• Managing Custom Services, page 87
• Adding or Editing a Custom Service, page 88
Managing Custom Services
Use the Firewall > Advanced Settings > Custom Services page to view, add, edit,
or delete custom services.
NOTE For a list of pre-configured services, see the Service description in the procedure
Adding and Editing Access Rules, page 67.
To open this page: In the navigation tree, choose Firewall > Advanced Settings >
Custom Services.
The Custom Services Table lists the details for the custom services that have
been defined.
Perform these tasks:
• To add a service, click Add. Then enter the settings on the Add/Edit Custom
Services Configuration page. See Adding or Editing a Custom Service,
page 88.
• To edit a service, check the box and then click Edit. Then enter the settings
on the Add/Edit Custom Services Configuration page. See Adding or
Editing a Custom Service, page 88.
• To delete a service, check the box and then click Delete. To select all
services, check the box in the heading row, and then click Delete. When the
confirmation message appears, click OK to continue with the deletion, or
otherwise click Cancel.