Cisco Small Business RV220W - Pppoe Profiles for Point-To-Point Protocol over Ethernet Connections; Managing Pppoe Profiles

Configuring Networking
WAN Settings for IPv4
Cisco RV220W Administration Guide 20
2
PPPoE Profiles for Point-to-Point Protocol over Ethernet
Connections
If you have a Point-to-Point Protocol over Ethernet (PPPoE) connection to the
Internet (used mainly with asymmetric DSL), create a PPPoE profile for your PPPoE
connection. You can create multiple profiles, which are useful if you connect to the
Internet using different service provider accounts.
• Managing PPPoE Profiles, page 20
• Adding and Editing PPPoE Profile Settings, page 21
Managing PPPoE Profiles
Use the Networking > WAN (Internet) > PPPoE Profiles page to view, add, edit, or
delete PPPoE profiles.
To open this page: In the navigation tree, choose Networking > WAN (Internet) >
PPPoE Profiles.
Perform these tasks:
• To add a profile, click Add. Then enter the settings on the Add/Edit PPPoE
Profile Configuration page. See Adding and Editing PPPoE Profile
Settings, page 21.
• To edit a profile, check the box and then click Edit. Then enter the settings on
the Add/Edit PPPoE Profile Configuration page. See Adding and Editing
PPPoE Profile Settings, page 21.
• To delete a profile, check the box and then click Delete. To select all profiles,
check the box in the heading row, and then click Delete. When the
confirmation message appears, click OK to continue with the deletion, or
otherwise click Cancel.