Cisco Small Business RV220W - User Log in Policies by IP Address

Administering Your Cisco RV220W
User Management
Cisco RV220W Administration Guide 167
9
User Log in Policies by IP Address
You can allow or deny access to a user based on his or her IP address.
• Managing IP Address Login Policies, page 167
• Configuring an IP Address Login Policy, page 168
Managing IP Address Login Policies
Use the User Policy By Source IP Address page to choose a policy type and to
view, add, edit, and delete IP addresses.
To open this page: From the Administration > User Management > Users page,
select a user then click Policies By IP.
The Username cannot be changed on this page.
STEP 1 At the top of the page, choose the type of policy:
• Deny Log in from Defined Browsers—Choose this option to prevent a user
from logging on when using an IP address in the Defined Addresses list. A
log in is allowed from a browser that is not in the list.
• Allow Log in only from Defined Browsers—Choose this option to allow a
user to log on only when using an IP address in the Defined Addresses list.
STEP 2 In the Defined Addresses table, perform these tasks:
• To add an address, click Add. Then enter the settings on the Defined
Address Configuration page. See Configuring an IP Address Login Policy,
page 168.
• To edit an address, check the box and then click Edit. Then enter the settings
on the Defined Address Configuration page. See Configuring an IP
Address Login Policy, page 168.
• To delete an address, check the box and then click Delete. To select all
addresses, check the box in the heading row, and then click Delete. Click
Save to continue with the deletion, or otherwise click Cancel.
STEP 3 Click Save to save your settings, or click Cancel to reload the page with the
current settings.