Configuring Virtual Private Networks (VPNs) and Security
SSL VPN Server
Cisco RV220W Administration Guide 131
6
STEP 2 In the SSL VPN Policy section, enter this information:
• Apply Policy to—Choose to apply the policy to a Network Resource, an IP
address, an IP network, or All Addresses that are managed by the device.
Also complete the fields that are highlighted with white backgrounds.
• Policy Name—Enter a name to identify this policy.
Note: If you create a policy with same name as that of any existing policy, the
newly policy overwrites the existing one.
• IP Address—If you chose IP Address or Network Resource in the Apply
Policy to field, enter the IP address of the device.
• Mask Length—If you chose IP Network in the Apply Policy to field, enter the
length of the subnet mask.
• Port Range / Port Number (Begin & End)—Specify a port or a range of
ports to apply the policy to all TCP and UDP traffic with those ports. Leave
the fields empty to apply the policy to all traffic.
• Service—Choose VPN Tunnel, Port Forwarding, or All Services Defined.
• Defined Resources—Choose the services for a particular policy. This
option is available only for policies that are applied to a Network Resource.
• Permission—Choose either Permit or Deny for this policy.
STEP 3 Click Save to save your settings, or click Cancel to reload the page with the
current settings. Click Back to return to the VPN > SSL VPN Server > SSL VPN
Policies page.
To Next Page
Loading...
