Cisco Small Business RV220W - Page 215

Installing the Cisco RV220W
Connecting the Equipment
Cisco RV220W Administration Guide 215
A
STEP 1 Connect one end of an Ethernet cable to the WAN port of the RV220W and the
other end to the Ethernet port of your cable or DSL modem.
STEP 2 Connect one end of a different Ethernet cable to one of the LAN (Ethernet) ports on
the back of the unit. (In this example, the LAN 2 port is used.) Connect the other
end to an Ethernet port on the PC that you will use to run the web-based Device
Manager.
STEP 3 Power on the cable or DSL modem and wait until the connection is active.
STEP 4 Connect the power adapter to the RV220W Power port.
!
CAUTION Use only the power adapter (12V, 1A) that is supplied with the unit. Using a different
power adapter could damage the unit.