Configuring Networking
LAN Configuration for IPv4
Cisco RV220W Administration Guide 27
2
- Starting and Ending IP Address—Enter the first and last of the
contiguous addresses in the IP address pool for this subnet. Any new
DHCP client joining the LAN is assigned an IP address in this range. You
can save part of the range for PCs with fixed addresses. These
addresses should be in the same IP address subnet as the VLAN IP
address that you specified above.
- Primary and Secondary DNS Server—DNS servers map Internet
domain names (for example, www.cisco.com) to IP addresses. Enter the
server IP addresses in these fields if you want to use different DNS
servers than are specified in your WAN settings.
- Lease time—Enter the duration (in hours) for which IP addresses are
leased to clients.
• DHCP Relay—Choose this option to enable the relay gateway to transmit
DHCP messages between multiple subnets. Then enter the address of the
relay gateway in the Relay Gateway field.
• None—Use this to disable DHCP on the VLAN subnet. If you want another
device on your network to be the DHCP server for devices on the VLAN
subnet, or if you are manually configuring the network settings of all of your
computers, disable DHCP.
STEP 3 In the LAN (Local Network) Proxy section, check Enable to enable the VLAN
subnet to act as a proxy for all DNS requests and to communicate with the ISP's
DNS servers.
STEP 4 Click Save to save your settings, or click Cancel to reload the page with the
current settings. If you are connected to the Cisco RV220W by the LAN port that is
a member of this VLAN, the system reboots and connects you to the RV220W
using its new IP address.
To Next Page
Loading...
Need help?
General
