Configuring the Wireless Network
Basic Settings
Cisco RV220W Administration Guide 55
3
- SSID Broadcast—Check the box to allow all wireless clients within
range to detect this wireless network when they are scanning the local
area. Disable this feature if you do not want to make the SSID known.
When this feature is disabled, wireless users can connect to this wireless
network only if they know the SSID (and provide the required security
credentials).
- VLAN—Enter the VLAN ID for this wireless network, if you have
configured multiple VLANs.
- Max. Associated Clients—Enter the maximum number of endpoints that
can use this wireless network. The default value is 20. You can change
this number if you want to restrict traffic on the network to prevent it from
being overloaded, for example.
• To edit the security mode for a wireless network, select a network and then
click Edit Security Mode. Enter the settings on the Wireless > Basic
Settings > Security Settings page. See Security Settings for Wireless
Networks, page 56.
• To restrict access to a wireless network based on MAC addresses, select a
network and then click Edit MAC Filtering. Enter the settings on the MAC
Filtering page. See MAC Filtering for Wireless Network Access Control,
page 58.
• To edit the multimedia settings for a wireless network, select a network and
then click Edit WMM. Then enter the settings on the WMM page. See Wi-Fi
Multimedia and Quality of Service Settings, page 60.
• To restrict access to a wireless network based on the day and time, select a
network and then click Edit SSID Scheduling. Then enter the settings on the
SSID Schedule page. See SSID Schedule for Network Availability,
page 61.
To Next Page
Loading...
Need help?
General
