Clear-Com HelixNet Partyline - Page 102

HelixNet | User Guide
l Slot 2 PCB
l Slot 3 PCB
Note: Slot 1, Slot 2 and Slot 3 refer to the interface module slots in the Main Station
extension bay. When looking at the rear of the module, slot 1 is the left-hand slot, slot
2 is the middle slot, and slot 3 is the right-hand slot.
The fourth menu displays the Part number, Revision and Serial numbers for the
PCB. The format is similar to the following:
Part xxxxxx
Revision: x
Serial: x
Where x is a numerical value.
5.8.2 Viewing temperature Information
To view the temperature of the Main Station:
1. In Menu mode, select Diagnostics and then Hardware.
2. From the third menu, select one of the following temperature sensors:
l Sensor 1
l Sensor 2
l Sensor 3
The fourth menu displays the temperature, for example:
+30°C
Environmental note:
The recommended operating temperature range for the HelixNet
HMS-4X Main Station is 0 to +40°C. The storage temperature range for the Main
Station is -30 to +70°C.
For more environmental information, see Installing HelixNet Partyline.
5.8.3 Viewing Powerline Information and Status
There are two digital Partylines (Line 1 and Line 2) on the HMS-4X Main Station. Line 1 and Line
2 are also referred to as powerlines.
Each line can support up to 10 beltpacks, Remote Stations or Speaker Stations.
Note: See also F, G and I in Main Station/Remote Station: Front panel-.
To view line information and status:
Page 102