Clear-Com HelixNet Partyline - Page 107

HelixNet | User Guide
To configure the settings for the SA output:
1. In Menu mode, select Audio Settings and then SA/Audio out.
2. To select the mode:
a. From the third menu, select Mode.
b. From the fourth menu, select one of the following:
n Channel Assigned (default). When this option is selected, SA will be available to
channels.
n SA. When this option is selected, SA will only be available to the SA output on the rear
of the remote station.
c. To confirm the selected setting, press the rotary control.
3. To select the gain:
a. From the third menu, select Gain.
b. From the fourth menu, select one of the following:
n +12dB
n +6dB
n 0dB (default)
n -6dB
n -12dB
c. To confirm the selected setting, press the rotary control.
4. The Program Output setting enables the program to be delivered to this output if it is assigned
to a Channel that also has another program feed assigned. To select the program output:
a. From the third menu, select Program Output.
b. From the fourth menu, select one of the following:
n Unmute (default)
n Mute
n [SA Mode]
c. To confirm the selected setting, press the rotary control.
Page 107