HelixNet | User Guide
5. The GPO trigger activates a relay when receiving audio in above the VOX level on a Partyline
Channel. You can enable or disable the GPO trigger.
a. In Menu mode, select Audio Settings and then Program Input.
b. From the third menu, select GPO Trigger.
c. From the fourth menu, select one of the following:
n Enabled (default)
n Disabled
d. To confirm the selected setting, press the rotary control.
Note: You can also configure the GPO trigger using Menu Mode > Modules
Settings.
6. To select the VOX:
a. From the third menu, select VOX.
b. From the fourth menu, select one of the following:
n Enabled
n Disabled (default)
c. To confirm the selected setting, press the rotary control.
7. To select the VOX Off Delay:
a. From the third menu, select VOX Off Delay.
b. From the fourth menus, select one of the following:
n .5 sec (default)
n 1 sec
n 2 sec
n 3 sec
n 4 sec
c. To confirm the selected setting, press the rotary control.
6.1.4 Audio Settings for the SA (Stage Announce) Output/4-Wire Out
On remote stations, SA can be disabled from channel assignment. Once SA is assigned to a
channel it becomes a resource consuming output. Not putting SA into channels will conserve
system resources.
Page 106
To Next Page
Loading...
