Issue Solution
I powered up two Main Stations
and they are not showing up in the
Networking > Stations list.
Make sure your Ethernet of Fiber cable is properly
connected to a router, a switch or another Main Station.
There is a green LED beside each Ethernet and Fiber port
to indicate that the connection is fine. Look at each station
IP address and Subnet Mask under Networking >
Preferences and make sure that they are part of the same
subnet. Also make sure that their IP address is different
from any other device on your IP network.
My connection to the CCM is
intermittent.
This is generally caused by more than one device using the
same IP address. Check with your network administrator
that there is no IP clash.
My device has gone into link-local
mode. (IP address =
169.254.XX.XX)
If your device is set to Dynamic Host Configuration
Protocol (DHCP) and there is no DHCP available on the
network, it is connected to it will revert to link-local
automatically. You need to allocate a static IP address to
this device. See Troubleshooting on page 281 for more
information.
To Next Page
Loading...
