Clear-Com HelixNet Partyline - Page 88

HelixNet | User Guide
5.6.2 Configuring a Two-Wire Interface Module
The following procedure shows you how to configure the Module Settings for a Two-wire interface
module.
Note: The Two-wire interface module must receive power from the Partyline.
To configure the Module Settings for a Two-wire interface module:
1. In Menu mode, select Module Settings.
2. From the second menu, select one of the two available ports on the two-wire interface
module:
Slot 1/Port A 2W
Slot 1/Port B 2W
Note: In this example, the two-wire module has been fitted to slot 1 in the expansion
bay. The expansion bay contains three slots.
2W = Two-wire.
a. To associate any available Channel (or to disable Channels associations) with
the selected port:
From the third menu (third display screen), select Channel Assign.
b. From the fourth menu, select one of the following:
n Disabled (default)
n Channel 1
n Channel 2
n Channel 3
n Channel 4
n ...
c. To confirm the selected setting, press the rotary control.
3. The Program Output allows a program feed associated with the Channel assigned to the four
wire port to either be delivered to that 4 wire port alongside the other Channel audio or not. To
set the Program Output:
a. From the third menu, select Program Output.
b. From the fourth menu, select one of the following:
Page 88