Clear-Com HelixNet Partyline - Page 87

HelixNet | User Guide
8. To confirm the selected setting, press the rotary control.
9. To set the GPO trigger for the Program Output:
a. From the third menu, select GPO.
b. From the fourth menu, select one of the following:
n Enabled
n Disabled
10. If you are setting up a continuous audio (program) feed using the four-wire interface module,
then you may want to enable the VOX functionality. To help reduce redundant noise, the
VOX functionality automatically deactivates and activates the continuous audio feed, at an
automatically determined volume threshold.
Note: If you assign a program and a four-wire interface to the same Channel, VOX is
automatically enabled.
To enable or disable VOX:
a. From the third menu, select VOX.
b. From the fourth menu, select one of the following:
l Enabled.
l Disabled (default)
c. To confirm the selected setting, press the rotary control.
11. The VOX Delay OFF setting determines the length of time to wait before deactivating the
incoming audio. To set the VOX Delay OFF setting:
a. From the third menu, select VOX Delay OFF.
b. From the fourth menu, select one of the following:
n .5 sec (default)
n 1 sec
n 2 sec
n 3 sec
n 4 sec
c. To confirm the selected setting, press the rotary control.
Page 87