HelixNet | User Guide
l +3 dB
l +2 dB
l +1 dB
l 0 dB (default)
l -1 dB
l -2 dB
l -3 dB
8. To set the Output Gain:
a. From the third menu, select Output Gain.
b. From the fourth menu, select one of the following:
n +3 dB
n +2 dB
n +1 dB
n 0 dB (default)
n -1 dB
n -2 dB
n -3 dB
9. To set the GPO trigger for the Program Output:
a. From the third menu, select GPO.
b. From the fourth menu, select one of the following:
n Enabled
n Disabled
10. Enabling RMK [Remote Mic Kill] Input allows an external 2-wire analogue partyline device
such as the main (base) station (MS-702) to send an RMK signal to the digital HelixNet
devices attached to the same HelixNet channel.
Note: If this is enabled and the analog Partyline system is powered down, it will be
interpreted by the HelixNet Main Station as an RMK input and all talk routes will be
switched off.
To enable RMK Input:
Page 90
To Next Page
Loading...
