HelixNet | User Guide
a. From the third menu (third display screen), select RMK Input.
b. From the fourth menu (fourth display screen), select one of the following:
l Enabled
l Disabled (default)
c. To confirm the selected setting, press the rotary control.
11. Enabling RMK [Remote Mic Kill] Output allows you to send an RMK signal from the HelixNet
Main Station to any connected analog 2-wire partyline system.
To enable RMK Output:
a. From the third menu, select RMK Output.
b. From the fourth menu, select one of the following:
l Enabled
l Disabled (default)
To confirm the selected setting, press the rotary control.
12. If you are setting up a continuous audio (program) feed using the two-wire interface module,
then you may want to enable the VOX functionality. To help reduce redundant noise, the VOX
functionality automatically deactivates and activates the continuous audio feed, at an
automatically determined volume threshold.
Note: If you assign a program and a two-wire interface to the same Channel, VOX is
automatically enabled.
To enable or disable VOX:
a. From the third menu, select VOX.
b. From the fourth menu, select one of the following:
l Enabled
l Disabled (default)
c. To confirm the selected setting, press the rotary control.
13. The VOX Delay OFF setting determines the length of time to wait before deactivating the
incoming audio. To set the VOX Delay OFF setting:
Page 91
To Next Page
Loading...
