Clear-Com HelixNet Partyline - Page 92

HelixNet | User Guide
a. From the third menu, select VOX Delay OFF.
b. From the fourth menu, select one of the following:
n .5 sec (default)
n 1 sec
n 2 sec
n 3 sec
n 4 sec
c. To confirm the selected setting, press the rotary control.
5.6.3 Configuring an Ethernet or Fiber interface module
The following procedure shows you how to configure the Module Settings for an Ethernet
interface module.
To configure the Module Settings for an Ethernet interface module:
1. To view status information about Main Stations:
a. In Menu mode, select Networking.
Note: The Networking menu only appears if at least one Ethernet or Fiber interface module is
detected.
b. From the second menu, select Stations. A list of station IDs is given for each
Main Station in the network. Each station ID in the list is preceded by the letter M-
for the Link-Master station itself and S- for all Link-Member (S stands for Slave).
c. From the third menu select the required station ID.
d. From the fourth menu you can view the following:
l Status – Enabled or Disabled
l IP – The IP address.
2. To edit or change the Hostname for your device:
a. In Menu mode, select Networking.
b. From the second menu, select Preferences
c. From the third menu, select Hostname
d. From the fourth menu, select the name by pushing and turning the Rotary controller.
e. Edit the name by turning the controller to select a letter or number and pushing to select it.
Page 92