HelixNet | User Guide
Then turn to scroll through letters. Push to commit.
f. When you have done, scroll to SAVE and push to commit.
3. To enable or disable DHCP:
a. In Menu mode, select Networking.
Note: The Networking menu only appears if an Ethernet or Fiber interface module is detected.
b. From the second menu, select Preferences.
c. From the third menu, select DHCP.
d. From the fourth display screen, select one of the following:
l Disabled
l Enabled (default)
4. To edit the IP address:
a. In Menu mode, select Networking.
Note: The Networking menu only appears if an Ethernet or Fiber interface module is detected.
b. From the second menu, select Preferences.
c. From the third menu, select IP Address.
d. From the fourth display screen, edit the IPv4 address.
Note: You can only edit the IPv4 address if DHCP is disabled.
Note: The HelixNet system uses 10.0.0.x and 172.23.x.x IP address ranges internally between the
Main Station and the Beltpacks, and therefore will not allow setting the external IP address to
anything in that range.
Note: If you change the IP address (either manually or through DHCP), the link between stations
will be broken and you have to reboot the Main Station to link again. The following message will
appear as a banner (inverted text) at the bottom across the four displays on the Main Station
IP address | changed, | reboot | to link
If that message appears, pressing the Menu key will bring you directly to: Administration->Reset-
>Reboot->Reboot Now
5. To edit the Gateway:
a. In Menu mode, select Networking.
Note: The Networking menu only appears if an Ethernet or Fiber interface module is detected.
Page 93
To Next Page
Loading...
