Horizon Imager User’s Manual 3-23
Basic Imager Operations
oÉëìãáåÖ=mêáåíáåÖ
With the imager in the Pause state, press the key again to
resume normal printing operations. If the imager has paused
due to a fault state, it will go back to the active state
automatically several seconds after the fault condition is
corrected, without you having to press the key.
NOTE:
If you do not press the key at the completion of maintenance operations,
normal printing operations will resume automatically after a predefined time-out period if the
imager is not in a Fault state. For information about how to adjust the time-out period
(typically, one minute), refer to the Horizon Imager Technical Manual.
The Hel p f unc tion provi des context- s ens i tive i nst ructions for ima ger
functions, parameters, and status messages. It also provides service
contact information.
Help text is displayed in two ways:
•
When any menu is displayed, help text relevant to the currently
selected menu option is automatically displayed in the Help
message area of the screen.
•
By pressing the key. Pressing the key displays
additional help text relative to the currently selected menu
option, currently selected status message, or state of the imager.
This additional help is displayed in its own Help window on top
of the current screen. You dismiss this Help window by pressing
the or key.
8
To resume
printing
PAUSE
PAUSE
3
PAUSE
rëáåÖ=låäáåÉ=eÉäé
HELP HELP
HELP
CANCEL
To Next Page
Loading...
