2-14 Setting Up the Imager
While you can certainly use your own IP address numbering
scheme in your simple network, you might want to adopt this
Internet convention. So, you might assign the IP addresses as
follows:
•
192.168.1.200
to the Horizon imager
•
192.168.1.201
to an image viewing workstation on the network
•
192.168.1.202
to a second workstation
•
192.168.1.203
to an imaging device
And so on.
TIP:
Labeling each device with its IP address
For convenience, you may want to affix a label to each device in the network that shows the
device’s IP address.
Specifying the Imager’s IP Address at the Control Panel
NOTE:
For a simple network, you will only need to define the imager’s base IP address. You
can leave all other network settings for the imager at their default values.
NOTE:
For instructions on how to use the imager’s control panel and menus, refer to
Chapter 3.
NOTE:
After entering the base IP address, note that the imager will reboot once you exit the
menus so that the software can be properly updated with the new value.
/
3
3
3
To Next Page
Loading...
