Horizon Imager User’s Manual 2-1
Setting Up the Imager
=O
pÉííáåÖ=ré=íÜÉ=fã~ÖÉê
To prepare for the Horizon imager installation, review the following
guidelines and requirements:
•
If this is a new installation, you will need to identify a table,
stand, or countertop on which to place the imager.
•
If you are replacing an existing imager, make sure that the
current location satisfies the Horizon imager installation
requirements.
•
Select a location for the imager that meets the requirements
described in “Location Precautions” on page xxxv in the
Preface.
•
Select a location that allows users easy access to the imager’s
control panel, supply cassettes, and receive trays.
•
Make sure an electrical outlet is nearby. It is recommended that
you use a UPS (uninterruptible power supply) to protect the
imager from voltage spikes and power outages.
mêÉé~êáåÖ=Ñçê=fåëí~ää~íáçå
CAUTION
Make sure that the table can support the weight of the imager
[approximately 66.7 kg (147 lbs) with receive trays and three full supply cassettes
installed].
To Next Page
Loading...
