Codonics Horizon - Changing Default Settings

8-2 Default Print Job Settings
If the factory-default settings do not meet your printing
requirements, you can change parameter settings at the control
panel. You can change the:
• Default media to use for grayscale or color images
• Default sheet and image parameter settings (referred to in the
administrative Main Menu as the “Default User Settings”) for
each media type
Changing the default settings overrides the factory defaults, but
does not delete them. You can easily reset the factory defaults at any
time. For more information, refer to “Resetting to Factory-Default
Settings” on page 8-7.
NOTE: Changes to the default settings apply only to new incoming print jobs. Jobs already
queued for printing are printed using the default settings that were in effect when the print
job was received.
`Ü~åÖáåÖ=aÉÑ~ìäí=pÉííáåÖë
CAUTION Changing the default settings will affect prints made by other users. Use
caution when changing default settings. Typically, it is better to specify sheet and
image parameter settings from the DICOM application or a PostScript printer’s
settings, or use a Job Settings file that contains the values you need. For information
about Job Settings files, refer to the Horizon Imager Technical Manual.
3