Horizon Imager User’s Manual 2-19
Setting Up the Imager
After generating a test print, try printing a sample image from each
imaging device and/or image viewing workstation on the network
to verify whether the network settings and cable connections are
properly configured.
•
If printing from one of the devices does not work, check that the
device is properly connected to the network and that its IP
address information is properly configured.
•
If you cannot print to the Horizon imager from any device,
check that the imager is properly connected to the network and
that its IP address information is properly configured.
For procedures on how to print to the Horizon imager:
•
To print from a DICOM application, refer to Chapter 5.
•
To print from an application via PostScript, refer to Chapter 6.
•
To print images from backup media, refer to the
Horizon Imager
Technical Manual
.
•
To send print jobs using FTP or LPR, refer to Chapter 7.
•
To send print jobs using an SA-2000 analog framegrabber, refer
to the
SA-2000 Operator Manual
.
qÉëíáåÖ=kÉíïçêâ=mêáåíáåÖ
To Next Page
Loading...
