Codonics Horizon - Alert and Fault Messages and the Fault Tone

3-12 Basic Imager Operations
^äÉêí=~åÇ=c~ìäí=jÉëë~ÖÉë=~åÇ=íÜÉ=c~ìäí=
qçåÉ
When the imager needs attention or an error occurs, the ALERT or
FAULT indicator lights. Also, “ALERT” and “FAULT” are displayed in
the Status screen’s title bar, and messages are displayed in the Status
screen to help you respond properly to the condition.
If operator intervention is required (for example, there is a sheet
jam), a Fault tone sounds. To stop the Fault tone, press any control
panel key.
TIP: Controlling the Fault tone volume or turning it off
You can control the volume of the Fault tone, or turn it off. For more information, refer to the
Horizon Imager Technical Manual.
For more information about alert and fault messages and how to
respond to them, refer to Chapter 12.
/