Horizon Imager User’s Manual 8-1
Default Print Job Settings
=U
aÉÑ~ìäí=mêáåí=gçÄ=
pÉííáåÖë
Every print job has parameters associated with it that control how
the job is to be processed (for example, media size and type,
scaling, gamma, contrast, and so on).
The Horizon imager has a complete set of
default settings
that
contain values for every media type/size, sheet, and image
parameter of a print job. The default settings are stored in the
imager and can be viewed and changed through the control panel.
Once changed, you can also change back to the original
factory-default settings at any time.
If a print job parameter has not been defined from within the
sending user application, in a selected Job Settings file, or in a Zip
disk
settings.txt
file, the imager’s Default Media and Default User
Settings are used.
Refer to Appendix D for a summary of the print job parameters that
can be changed at the control panel. Note that many of these
parameters require a good understanding of what effect changing
the parameter’s setting will have on printed images and sheets. For
a full discussion of each parameter, refer to the
Horizon Imager
Technical Manual
. You can also refer to the Technical Manual for
information about using Job Settings files and printing files
automatically from a Zip disk.
CAUTION
Use caution when changing the imager default settings. Changes could
affect prints made by other users.
To Next Page
Loading...
