Horizon Imager User’s Manual 2-17
Setting Up the Imager
8. Press the or key to leave the Network Settings menu.
A message states that the imager will automatically reboot when
you press the key to exit the Main Menu.
9. Press the key to acknowledge the message.
10. When you are finished specifying the IP address and want to
exit the Main Menu, press the key.
Because the base IP address was defined, the imager reboots so
that it can be identified properly on the network.
NOTE:
You can reset the network settings to their default values at any time by selecting the
Reset Network Settings
option in the Network Settings menu.
péÉÅáÑóáå Ö=fm=^ÇÇêÉëëÉë=Ñçê=líÜÉê=aÉîáÅÉë=
çå=íÜÉ=kÉí ïçêâ
Just as you did for the Horizon imager, you must specify the IP
addresses for each of the other devices on the network. How you
do this varies, depending on the device and its operating system.
For this reason, you will have to refer to the documentation or
online help that comes with the device for specific instructions.
For more information about IP addressing conventions, refer to the
Horizon Imager Technical Manual
.
After setting the imager’s IP address, you can load media cassettes
and, optionally, load a ribbon to support color prints. For more
information about how to load media, refer to “Inserting or
Changing Cassettes” on page 4-4 and “Changing the Ribbon
(ChromaVista)” on page 4-8.
CANCEL
MENU
ENTER
MENU
3
iç~ÇáåÖ=jÉÇá~
To Next Page
Loading...
