Horizon Imager User’s Manual 8-5
Default Print Job Settings
`Ü~åÖáå Ö=aÉÑ~ì äí=rëÉê=pÉííáåÖë=Ñçê=~=
jÉÇá~=qóéÉ
You can change the Default User Settings (that is, the default sheet
and image parameter settings) for each available media type
supported by your imager.
1. At the imager’s control panel, press and hold the key, and
while holding it press the key.
The Main Menu with administrative options displays.
2. Select the
Default User Settings
option, then one of the
following media types:
DV Film Blue
DV Film Clear
DV Paper
CV Paper
The current parameter settings are displayed for that media
type. For example, selecting
DV Film Blue
displays the following
list of parameters and their current settings. In this example, the
current default value for Gamma is 1.0.
NOTE:
For information about the parameters and their possible settings, refer to Appendix D
or to the Horizon Imager Technical Manual.
Menu
Default User Settings
DV Film Blue
Gamma
[1.0]
Contrast
[0]
Dmax
[300]
Dmin
[0]
Film View
[Front]
Adjust overall brightness and
darkness of print.
Press MENU to exit menus
8
To change
Default Use
Settings for a
media type
MENU
3
To Next Page
Loading...
