Codonics Horizon - Preparing the Imager for Shipment

2-26 Setting Up the Imager
If you have to ship the imager for any reason (for example, to return
the imager to Codonics for service), you must use the original
imager box and packing materials. If you do not have the original
box and packing materials, contact your Codonics representative for
instructions on how to return the imager.
1. If a ribbon is in the imager, remove it. For more information,
refer to “Changing the Ribbon (ChromaVista)” on page 4-8.
2. Make sure the top cover is closed and the receive trays are
inserted.
NOTE: The top cover must be closed and the receive trays must be inserted for the thermal
print head to park. If either the top cover is open or the receive trays are not inserted, the
imager will display a message indicating that it cannot be shut down until the condition is
corrected.
3. Power off the imager. For more information, refer to “Powering
Off the Imager” on page 3-7.
4. Remove the receive trays.
mêÉé~êáåÖ=íÜÉ=fã~ÖÉê =Ñçê=pÜáéãÉåí
8
To prepare the
imager fo
r
shipmen
t
3