Horizon Imager User’s Manual xxxi
Preface
p~ÑÉíó=mê ÉÅ~ìí áçåë
•
Never connect this imager to any outlet or power supply that has
a voltage or frequency different than that specified on the rear
of the imager.
•
When servicing the imager, always power it off using the
(power) key at the control panel, then turn the rocker switch
in the back
to the
0
(off) position, then unplug the imager.
•
Damage to the power cord may cause fire or shock hazard.
When unplugging the power cord, hold it by the plug only and
remove the plug carefully.
•
If the power cord needs to be replaced, replace it only with
another Codonics power cord manufactured specifically for your
imager’s power configuration.
•
If the imager is smoking or making unusual sounds, power off
and unplug the imager immediately.
•
Do not insert foreign objects of any kind into the imager; doing
so can constitute a safety hazard and cause extensive damage.
•
Do not place any liquid containers on the imager. If, for some
reason, liquid seeps into the imager, power off the imager and
unplug the power cord from the source outlet. If used without
corrective measures, the imager may be damaged.
•
Do not use the imager near flammable gases.
To Next Page
Loading...
