2-24 Setting Up the Imager
oÉëíçêáåÖ=íÜÉ=`çåÑáÖìê~íáçå=pÉííáåÖë=Ñê çã=
_~Åâìé=jÉÇá~
1.
If your Horizon has a Zip drive
, open the SmartCard access door
at the lower right front of the imager and
insert
the 100-MB
backup Zip disk into the imager Zip drive.
If your Horizon does not have a Zip drive
, insert the backup USB
flash drive into one of the USB ports on the rear panel.
2. At the imager’s control panel, press and hold the key, and
while holding it press the key.
The Main Menu with administrative options displays.
3. Select the following menu options:
Utilities
Save/Load Config
Load Config
A message prompts you to confirm that you want to load the
imager configuration from the backup media.
4. Press the key to confirm the restore operation.
The configuration is copied onto the imager from the backup
media. Then the imager reboots so that the restored settings can
take effect.
8
To restore
configuration
settings
MENU
ENTER
To Next Page
Loading...
