Codonics Horizon - Specifying a Job Settings File from a DICOM User Application

Horizon Imager User’s Manual 5-7
Printing from DICOM
Applications
péÉÅáÑóáåÖ=~=gçÄ=pÉííáåÖë=cáäÉ=Ñêçã=~=
af`lj=rëÉê=^ééäáÅ~íáçå
You may see several destination imager devices in your DICOM
application, all of which actually print to the same Horizon imager.
They just represent different Job Settings files, each assigned its
own Called AE Title, so that you can use various job settings that
are supported by the imager but that you cannot specify from within
the application’s standard interface.
For example, the system Job Settings file that specifies DirectVista
8 x 10 blue film is 8x10-dvfb . To specify DirectVista 8x10 blue
film for a print job, the DICOM user application would use
8x10-dvfb as the Called AE Title when starting a Print Service Class
session with the Horizon imager. The Horizon imager, knowing that
its DICOM print service was requested using the Called AE Title
8x10-dvfb , would look in the Job Settings file named 8x10-dvfb to
see which sheet and image settings should be applied to the print
job (in this case, only the media type and size).
The Horizon imager also supports being assigned multiple IP
addresses for some systems that do not support configuring more
than one printer per IP address. For more information about
multiple IP addresses and how DICOM printing to the Horizon
imager can be implemented, refer to the Horizon Imager Technical
Manual .