Codonics Horizon - Printing from Macintosh Applications; Specifying the Horizon Media

6-16 Printing via PostScript
7. When you are done changing settings, click OK to save your
changes.
The settings you have saved will be in effect for the current
session of the application from which you are printing. If you
open a new session of the application or print from a different
application, the parameters revert to their default settings.
Once the Horizon imager is set up as a printer on your Macintosh
(which is described in the two
Macintosh Driver Installation—
Horizon Technical Briefs, one for OS 8 and 9 and one for OS X),
you can send images to it for printing from any Macintosh
application.
To print to the Horizon imager, you first use the application’s Page
Setup function to select the Horizon media size and type. Then, you
use the standard Print dialog box to select the Horizon imager as
the print destination and set the Horizon PostScript parameters.
péÉÅáÑóáåÖ=íÜÉ=eçêáòçå=jÉÇá~
Before sending a print job to the Horizon imager, you must select
the Horizon media size and type using the application’s Page Setup
function. The available choices are listed in Table 6-2 on page 6-21.
mêáåíáåÖ=Ñêçã=j~ÅáåíçëÜ=^ééäáÅ~íáçåë