Horizon Imager User’s Manual 2-23
Setting Up the Imager
j~å~ÖáåÖ=vçìê=_~Åâìé=jÉÇá~
Once you create a backup Zip disk or USB flash drive with the initial
imager settings, you may not want to reuse that backup media. If
you run another Save Config function with this backup media
inserted, the old configuration settings will be overwritten.
It is recommended that each time you make significant changes to
the imager’s settings, you save them to a separate backup media.
Only reuse a backup media if you are certain that you would not
want to restore the configuration settings already stored on it.
Keep all backup media in a safe place.
To Next Page
Loading...
