Horizon Imager User’s Manual 2-9
Setting Up the Imager
NOTE:
Depending on the specific configuration, your imager may include an optional
Ethernet filter cable. If provided, make sure to insert the Ethernet filter cable into the imager
network connector. Then insert the Ethernet cable into the Ethernet filter cable.
NOTE:
Your imager may include an optional modem. The modem connectors look similar to
the network connector (but are slightly smaller). Make sure you insert the Ethernet cable jack
into the network connector. For more information about the modem (if there is one), refer to
the additional modem documentation that came with the imager.
2. Connect the other end of the Ethernet cable to the Ethernet hub
or, if your configuration includes only a workstation and the
imager, to the workstation’s Ethernet jack.
NOTE:
When connecting the imager to only one workstation, you must use a special
Ethernet cable, called a crossover cable. This cable eliminates the need for a hub.
Optionally, you could still connect the imager and the single workstation using two standard
Ethernet patch cables and a hub. This would allow for future expansion of the network.
You are now ready to power on the imager. Refer to the next topic.
3
3
3
To Next Page
Loading...
