3-8 Basic Imager Operations
TIP:
Bypassing the Power menu
To start the shutdown process without having to display the Power menu, press and hold the
key for a few seconds, until you see shutdown messages appear in the control panel
display.
CAUTION
If the imager is powered off using the key, unprinted queued jobs are
saved and will finish printing once the imager is powered on again (you can purge all
jobs). However, if the imager is powered off using the rocker switch in the back or
power is interrupted (for example, an unexpected power failure), queued jobs may be
lost.
WARNING When servicing the imager, always power it off using the key, turn
the rocker switch in the back to the
0
(off) position, then unplug the imager.
/
To Next Page
Loading...
