EXAMPLE OF CONNECTION
CONNECTION OF ANALOGUE OUTPUTS (1/2)
The optoisolated section of the analogue outputs requires an external power supply at 24 Vdc which may be connected to the same
power supply as the load or separately if high precision of the signal on the load device is required.
1. Common power supply
This type of connection requires the use of a single power supply connected both to the load device and to the optoisolated section of
the analogue outputs. 0 V must be connected to earth on the terminal of the power supply.
INTEGRATION GUIDE C3G Plus
4-32 00/1097
PARALLEL I/O C3G-ADM
To Next Page
Loading...