Comau C3G Plus - Deleting Files Present on PC; File Management between PC and Cell Controller; Transferring Files from Controller to PC; Transferring Files from PC to Controller

FILE MANAGEMENT BETWEEN PC AND CELL CONTROLLER
Below is a description of the procedures for deleting, displaying and transferring files via PC. To do this it is
necessary to use the PCINT programme, which must be installed on the PC; for PCINT programme set up
and use, refer to the “PCINT PROGRAMME” paragraph in chapter 3 of the manual.
After installing the programme, select the VIDEO/C3G KEYBOARD EMULATOR option and from the sys
-
tem/keyboard menu type the commands indicated by the procedures.
DELETING FILES PRESENT ON PC
·
Typing the command ALT-D on the PC it is possible to see/change the directory selected.
·
Type the command FD (Filer, Delete): <COMP:(FILE_NAME)> and press ENTER on the PC.
TRANSFERRING FILES FROM PC TO CONTROLLER
·
Typing the command ALT-D on the PC it is possible to see/change the directory selected.
·
Type the command FC (Filer, Copy): <COMP:(FILE_NAME)> and press ENTER on the PC; the follow
-
ing message will be displayed:
Destination file name
·
Type destination file name, <RD:(FILE_NAME)> and press ENTER on the PC; at the end of the opera
-
tion the word:
Done
Items between round brackets may be omitted.
TRANSFERRING FILES FROM CONTROLLER TO PC
· Typing the command ALT-D on the PC it is possible to see/change the directory selected.
· Type the command FC (Filer, Copy): <RD:(FILE_NAME)> and press ENTER on the PC; the following
message will be displayed:
Destination file name
·
Type the destination file name, <COMP:(FILE_NAME)> and press ENTER on the PC; at the end of the
operation the word:
Done
Items between round brackets may be omitted.
DISPLAYING FILES PRESENT ON PC
·
Typing the command ALT-D on the PC it is possible to see/change the directory selected.
·
Type the command FV (Filer, View): <COMP:(FILE_NAME)> and press ENTER on the PC. The file se
-
lected will be displayed.
AUTOMATIC FILE TRANSFER FROM CONTROLLER TO PC
·
Type the FUB command (Filer, Utility, Backup). This command saves the files specified on the backup
device (FD COMP: or COM0:) which is recognised automatically. In the case of COM0: Kermit commu
-
nication protocol must be installed on the PC.
MAIN OPERATIONS FOR SYSTEM USE C3G Plus
5-10 00/1097
FILE MANAGEMENT