AUTOMATIC FILE TRANSFER FROM PC TO CONTROLLER
·
Type the FUR command (Filer, Utility, Restore). This command copies in the RAM Disk files coming
from the external device (FD COMP: or COM0:) which is recognised automatically. In the case of
COM0: Kermit communication protocol must be installed on the PC.
USE OF THE FLOPPY DISK UNIT
All cell controllers can be fitted with floppy disk unit (FDU) the use of which is described below.
FILE TRANSFER FROM RAM DISK TO FLOPPY DISK
·
Press the programming terminal key TOP to return to the main menu, and type the command FC (Filer,
Copy).
·
The programming terminal display shows the following message:
Source file name (OPT):
·
After activating the characters menu, type in RD: followed by the name of the file to be copied.
·
The programming terminal display shows the following message:
Destination file name
·
After activating the characters menu, type in FD: followed by the name of the file to be copied.
FILE TRANSFER FROM FLOPPY DISK TO RAM DISK
· Press the programming terminal key TOP to return to the main menu, and type the command FC (Filer,
Copy).
· The programming terminal display shows the following message:
Source file name (OPT):
· After activating the characters menu, type in FD: followed by the name of the file to be copied.
·
The programming terminal display shows the following message:
Destination file name:
·
After activating the characters menu, type in RD: followed by the name of the file to be copied.
C3G Plus MAIN OPERATIONS FOR SYSTEM USE
00/1097 5-11
file management
To Next Page
Loading...