UTILITY COMMAND
Applicatn Communicn
Configure Display Execute Filer Memory Program Set Utility
The UTILITY command displays a menu of commands that handle special purpose features of the system.
Applicatn
The APPLICATN command allows the user to start an application programme. The application programme
must be running before this command is issued and must be programmed to handle a call for application aid.
This command activates the EZ application if this has been installed previously. To use this command, sys
-
tem and memory protection must both be off.
Syntax: UA
Communicn
Dismount Mount Port_char Set_def View
Applicatn Communicn
The COMMUNICN command displays a menu of commands that handle data communication devices for the
controller. These devices include serial ports and network devices.
· Dismount disconnects the protocol currently activated on a communication device.
Syntax: UCD <comm_port>
· Mount displays a menu of communication protocols to be activated on a certain communication device.
If a device is not specified, the default one will be used.
Crt_emu Ddcmp Kermit Tisoft 3964 R
Dismount Mount
Port_char Set_def View
·
Crt_emu activates the video emulation protocol. Before entering this command, make sure that the
video emulation programme is running on the PC and that the serial line cable is connected to the speci
-
fied port. Use the UTILITY COMMUNICN DISMOUNT command to exit the video emulation environ
-
ment.
Syntax: UCMC <port_name>
·
Ddcmp activates the DDCMP protocol on a serial port. A port name is required as parameter. While
DDCMP is mounted on a port, that port must be referenced as DCMn: instead of COMn:. When DDCMP
is dismounted, the port is accessed using COMn:.
Options: /Maint activates the maintenance mode of the DDCMP protocol.
Syntax: UCMD <port_name>
·
Kermit activates the Kermit protocol of a serial port. This protocol is mainly used for file transfers be
-
tween the controller RAM disk and the serial port. It can handle packages up to a maximum of 2000
bytes in length.
Options: /Speed changes the default baud rate for the protocol. A speed parameter is required
to
specify the new baud rate.
Syntax: UCMK <port_name>
OPERATOR INTERFACE C3G Plus
3-56 03/0499
UTILITY COMMAND
To Next Page
Loading...