14) HELPIO.COD
HELPIO.DOC
: It permits to configure the help of the command DISPLAY INPUT/OUT
-
PUT.To this purpose, the program HELPIO.COD has to be modified (by
PROGRAM EDIT) and sent to execution (by PROGRAM GO), after loading
the program HELPIO2:COD to the memory (by MEMORY LOAD.
15) COMAFEAF.GSD : Makes it possible to configure the DP SLAVE Profibus on PLC.
16) COMAO4A1.GSD : Enables configuration of card PF-DP by means of the PLC
17) C3G_EDN.EDS : It permits to configure DeviceNet from PLC.
C3G Plus INTEGRATION GUIDE
06/0400 4-35
SERIAL I/O AND PDL2 TOOLS
To Next Page
Loading...