©2025 Copeland LP.
026-1803 R13 Supervisor I&O User Guide A - 3
Read Data
Failed AI 02
System
Alarm
OnBoard
Should be generated if sensors are configured but
disconnected. If the advisory is reset, and the alarm/notice
condition still exists, the delay period will be used. Advisories
will return to normal if the command value stays in the non-
alarm/notice condition.
Read Data
Failed AI 03
System
Alarm
OnBoard
Should be generated if sensors are configured but
disconnected. If the advisory is reset, and the alarm/notice
condition still exists, the delay period will be used. Advisories
will return to normal if the command value stays in the non-
alarm/notice condition.
Read Data
Failed AI 04
System
Alarm
OnBoard
Should be generated if sensors are configured but
disconnected. If the advisory is reset, and the alarm/notice
condition still exists, the delay period will be used. Advisories
will return to normal if the command value stays in the non-
alarm/notice condition.
Read Data
Failed AI 05
System
Alarm
OnBoard
Should be generated if sensors are configured but
disconnected. If the advisory is reset, and the alarm/notice
condition still exists, the delay period will be used. Advisories
will return to normal if the command value stays in the non-
alarm/notice condition.
Read Data
Failed AI 06
System
Alarm
OnBoard
Should be generated if sensors are configured but
disconnected. If the advisory is reset, and the alarm/notice
condition still exists, the delay period will be used. Advisories
will return to normal if the command value stays in the non-
alarm/notice condition.
Read Data
Failed AI 07
System
Alarm
OnBoard
Should be generated if sensors are configured but
disconnected. If the advisory is reset, and the alarm/notice
condition still exists, the delay period will be used. Advisories
will return to normal if the command value stays in the non-
alarm/notice condition.
Read Data
Failed AI 08
System
Alarm
OnBoard
Should be generated if sensors are configured but
disconnected. If the advisory is reset, and the alarm/notice
condition still exists, the delay period will be used. Advisories
will return to normal if the command value stays in the non-
alarm/notice condition.
Network
Device
Offline
System
Alarm
None
The current controller could not find the specified device
controller. Device applications will generate an Offline advisory
if the device fails to communicate after it is commissioned.
When the advisory is generated, the status of the application
will be offline.
Control
Temp High
Alarm
Application
Alarm
AHU
A control temperature advisory should occur after a user
specified time delay for both high and low temperature
conditions. This advisory should have associated parameters to
allow the user to specify the high and low advisory value and
the delay. This advisory should have separate setpoints for
occupied and unoccupied mode.
Alarm Items Category Cell Name Description
To Next Page
Loading...