DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
227
Figure 8-60 Standard IPv6 ACL (Add Rule) window
The fields that can be configured are described below:
Parameter Description
Rule Number Enter the ACL rule number here. This value must be between 1 and
65535. If this value is not specified, the system will automatically
generate an ACL rule number for this entry.
Action
Select the action that this rule will take here. Options to choose from
are Permit and Deny.
Source
Select and enter the source information here. Options to choose from
are Any, Host, and IPv6. When the Any option is selected, any source
traffic will be evaluated according to the conditions of this rule. When
the Host option is selected, enter the source host’s IPv6 address here.
When the IPv6 option is selected, the Prefix Length option will also be
available. Enter the source IPv6 address and prefix length value in the
spaces provided.
Destination
Select and enter the destination information here. Options to choose
from are Any, Host, and IPv6. When the Any option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host’s
IPv6 address here. When the IPv6 option is selected, the Prefix
Length option will also be available. Enter the destination IPv6
address and prefix length value in the spaces provided.
Time Range
Enter the name of the time range to associate with this ACL rule.
Click the Back button to discard the changes made and return to the previous page.
Click the Apply button to accept the changes made.
To enable the Counter State option or to enter a Remark for the profile, click the Edit button, next to the
specific ACL profile (found in the ACL profile table).
To Next Page
Loading...
