DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
235
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host’s
IPv6 address here. When the IPv6 option is selected, the Prefix
Length option will also be available. Enter the destination IPv6
address and prefix length value in the spaces provided.
Specify ICMP Message Type
Select the ICMP message type used here.
ICMP Message Type When the ICMP Message Type is not selected in the Specify ICMP
Message Type drop-down list, enter the ICMP Message Type
numerical value used here. When the ICMP Message Type is selected
in the Specify ICMP Message Type drop-down list, this numerical
value will automatically be entered.
Message Code When the ICMP Message Type is not selected in the Specify ICMP
Message Type drop-down list, enter the Message Code numerical
value used here. When the ICMP Message Type is selected in the
Specify ICMP Message Type drop-down list, this numerical value will
automatically be entered.
DSCP
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Flow Label
Enter the flow label value here. This value must be between 0 and
1048575.
Time Range
Enter the name of the time range to associate with this ACL rule.
After selecting the Protocol ID option as the Protocol Type, the following page and parameters will be
available, as shown below:
Figure 8-70 Extended IPv6 ACL (Add Rule) Protocol ID window
The dynamic fields that can be configured are described below:
Parameter Description
Protocol
Enter the Protocol ID value used here. This value must be between 0
and 255.
Fragments Select the Fragments option to include packet fragment filtering.
Source
Select and enter the source information here. Options to choose from
To Next Page
Loading...
